Arduino UNO R3 SMD Development Board Compatible with USB Cable
Arduino UNO R3 SMD Development Board Compatible with USB Cable
Arduino UNO R3 SMD Development Board Compatible with USB Cable
₹399 (76% OFF) ₹999

About this item

  • ATmega328P with 16 MHz clock speed, 8-bit architecture, 32 KB flash memory, 2 KB SRAM, and 1 KB EEPROM.
  • 14 pins for digital input/output operation
  • 6 pins for reading analog signals with a 10-bit ADC
  • 6 pins capable of Pulse Width Modulation for controlling LED brightness, motor speed, etc
  • USB Interface: For programming and power supply
Product Policy:
  • Buyer Protection.
  • Full Refund if you don't receive your order.
  • Returns accepted if product not as described.

Product Description

Tuteby UNO Board - A best Development board for young Enthusiastic.

Banner1The UNO R3 board is ideal for getting started with electronics and coding.

This adaptable microcontroller features the popular ATmega328P and ATMega 16U2 processors, offering a fantastic introduction to the Arduino IDE.

2 x 8-bit timer/counter with a special period register and comparison channels, 1 x 16-bit timer/counter with a dedicated period register, input detection and comparison channels, 1 x USART with fractional baud rate generator and start-of-frame detection, 1 x controller/peripheral device serial peripheral. al Interface al Interface al Interface al 1 x dual-mode controller/peripheral I2C1x analogue comparator (AC) with scalable reference input. Watchdog timer with separate on-chip oscillator. Six PWM channels. Pause and wake up when changing the pin

Banner2Banner 3Microcontroller ATmega328P microcontroller

Input voltage: 7-12 V

Clock Speed 16 MHz

Component listing 1 x UNO R3 development board, 1 x USB cable

flash 32K

SRAM, EEPROM 2KB SRAM 1KB EEPROM

Banner 5

  • Buyer Protection.
  • Full Refund if you don't receive your order.
  • Returns accepted if product not as described.

About this item

  • ATmega328P with 16 MHz clock speed, 8-bit architecture, 32 KB flash memory, 2 KB SRAM, and 1 KB EEPROM.
  • 14 pins for digital input/output operation
  • 6 pins for reading analog signals with a 10-bit ADC
  • 6 pins capable of Pulse Width Modulation for controlling LED brightness, motor speed, etc
  • USB Interface: For programming and power supply

CUSTOMER REVIEWS

PRODUCT REVIEWS

0/5.0

(0)
5
0 Reviews
4
0 Reviews
3
0 Reviews
2
0 Reviews
1
0 Reviews

CUSTOMER ALSO VIEWED

PRODUCTS THAT CUSTOMER VIEWED